Cylinder head - Min Tec head range

I'm often asked about the range of cylinder heads I do for Mini Spares/Mini Mania, so here's the low-down…

Although the following range of heads accommodate specific fitments - like pre-1992 where by-pass hoses and heater take-offs on the clutch end of the head are used and post-1992 where neither of these exist, and on SPi (single point injection) heads where they don't usually have a threaded hole for the temperature sender - in reality it is easy to convert almost any of them to fit any other engine since holes are easily blocked off - or by-pass hoses not used, water pumps blanked off and drilled thermostats fitted (see articles on cooling/engine transplants). A list of which is what and what to do to each to convert is at the end of this article.

For more in-depth descriptions of the head specs, see article 'Cylinder head - About Min Tec Heads' - basically the valve sizes used have been decided on after extensive and in-depth flow test...

Engine - 998 tuning, further options

Terminology:
MSC/MM - Mini Spares Centre/Mini Mania
BBU - Big Bore Unit (refers to all 1275cc-based units)
SBU - Small Bore Unit (refers to all sub-1275cc units, here the 998)
BHP - Brake Horse Power
CR - Compression Ratio

To improve engine out-put, you need to increase the engine's 'breathing' ability. The stage one kit deals with all the easily bolted-on external parts, and represents the best increase for investment. From here on in the power increases will cost commensurately more money. Power production of any engine, once the 'breathing apparatus' (induction/exhaust system) has been dealt with to cause no restriction ...

Cylinder head 2022